Guangzhou Zhenroumei Chemical Coatings Limited

BOYET Series Product Name/Model：BM2K Solid Colors  Characteristic：BM2K Solid Colors, high gloss and build, good performance of leveling property, easy construction, excellent pretective and coveraging power, long lasting bright color. Mainly applies to intermediate cars, MPV and bus. Substrates Well-Sanded, Completely dried and good existing finishes as bellow: A original paint B. Old paint firm C. 1K or 2k primer Surface Cleaning Wash by warm soap, remove wax, silicon and other contaminations with degreaser, sanding with P800-P1000, wash with clean water then keep dry; again with degreaser. Mixing Ratio BM2K Solid Colors  Hardener  Thinner 2 1 0.2~0.4 ＜15℃ BM2K Solid Colors  210 Fast Hardener  BYTX-1 Fast Thinner 15-30℃ BM2K Solid Colors  220 Standard Hardener BYTX-2 Standard Thinner ＞30℃  BM2K Solid Colors  230 Slow Hardener   BYTX-3 Slow Thinner Spray Viscosity 16-19s to drop off, in 4# viscosity cup, at 25°C, Pot-life At 25°C 2 hours with fast hardener. 4 hours with standard or slow hardener. ReTreatment There are particles or runs after spray, sand affected area with P2000 sand paper after thorough drying, then polish to solve the problem. Spray Gun Set Up Gravity Feed: 1.2-1.5mm 3-5kg/cm 2 Suction Feed: 1.4-1.6mm 3-5kg/cm 2 Spray Technology Coats&Thickness: 2-3 coats, total 35-50um Flash-Off Time: At 25°C, 5-10 minutes between two coats, Air-Drying Time: Allow 10-15 minutes air drying time before force drying Drying Time Temperature Dust Free Tack Free Dry To Handle   Dry To Test +25°C 40 minutes 2 hours   9 hours  6 Days +70°C 5 minutes  10 minutes  25 minutes 50 Minutes Shelf Life 2 years in original sealed can, cool and dry place at 25℃. Package   1L×12 or 3.75L×4 Note: 1. The substrate must be cleaned and sanded before spray, wet sanding P800-1000 and then dry. 2. At ambient temperature higher than 30℃, add appropriate Retarder Solvent into thinner to avoid blushing. For more details, please refer to technical data sheet of Retarder Solvent. 3. The products mixed with hardener should be used up soon and can not be restore for future use; clean equipments immediately with thinner after application, otherwise it is very difficult to be cleaned after dry.